Product Features

Ⅰ. Setting Guide & Button Instruction   

Step1: Place the gray adapter and orange stopper in the bottom of the cup

Step 2: Connect the cup with the main machine

Step3: Pull the gray adapter and the pressure will be released

On/off button

On/off button

Press and hold for more than 3 seconds to turn on or off. To short press once during negative pressure use, the negative pressure stops pressurizing, the lights flash in sequence, and the massager will decompress and enter standby mode (if the heating function is running, then it would show heating lights). Clicking the on/off button again to continue the negative pressure function.。

Negative pressure button

Negative pressure button

Short press the button to start the negative pressure, which has six gears in total corresponding to the 1-6 white lights. Repeatedly short press the button to switch between 1 to 6 gears and turn off the negative pressure function cycling.

Red light button

Red light button

Short press the red light button to turn on or turn off the button backlight and the red light on the bottom of the machine.

Heating button

Heating button

Short press to start heating. There are six levels of heating temperature, corresponding to the 1-6 red lights. By repeatedly short pressing the button, you can switch between gear 1 to gear 6.

Ⅱ. The Three Main Functions of the Massager

Scraping massage: when scraping massage, you can tilt the product 20° to 45° using the angled edges to start the massage.

Massage: Short press to start heating. There are six levels of heating temperature, corresponding to the 1-6 red lights. By repeatedly short pressing the button, you can switch between gear 1 to gear 6. It is suitable for human body to do a warming massage.

Suction massage: Short press the button to start the negative pressure, which has six gears in total corresponding to the 1-6 white lights. By repeatedly short pressing the button to switch between 1 to 6 gears and turn off the negative pressure function cycling. The default setting starts with gear 1, pressing the button to switch up the gear until reach an appropriate gear. Once the gears are set, the massager can be used for static suction or mobile suction. (You can set the heating temperature according to your body conditions).

(Note: DO NOT scraping and massaging and suctioning on eyes, lips, tongue, ears, nostrils, nipples, navel, and abdomen; scraping and massaging will cause congestion in these areas and they WILL NOT heal.)

      1. Scraping massage schematic

In general, the scraping starts with neck, shoulder, back (thoracic, lumbar, and sacral), upper extremity, and then lower extremity. Please follow your doctor's instructions or use as directed by your doctor.

Product Charging and Display

I. Product Charging Status Indication

Description of power indication

statusesindications
out of power The first light flashes red three times and shuts off automatically after one ring
chargingThe machine will stop working and the gear lights will flash in sequence
fully chargedWhen the battery is fully charged, the charging display light is fully illuminated; if charging continues for more than 30 seconds, the light automatically goes off the screen.

Description of power indication

After powering on, the display shows 3 seconds of battery remaining.
The first light flashes (red light) when 10% of the battery remains.
The second light flashes (white light) when 20% of the battery remains. The third light flashes (white light) when 40% of the battery is remaining. The fourth light flashes (white light) when 60% of the battery is remaining. The fifth light flashes (white light) when 80% of the battery is remaining. The sixth light flashes (white light) when the power level is less than 100%. When the power is below 10%, the display light 6 red lights will flash cyclically, accompanied by 9 beeps, and the power will shut off after 10 seconds

II. Battery Charging

When the battery is fully charged, the screen shows the full charge status, and if it continues to charge for more than 30 seconds, the screen automatically rests.   
Note: The output voltage range of the charger is limited to 4.5-5.5v, since the battery will not be fully charged when less than 4.5v and the product might be damaged when over 5.5v.                                                                                                                                                                                      

Ⅲ. Battery Over-temperature Protection

The product will automatically shut down when the temperature around the battery reaches and exceeds 60°C. In order to prevent accidents such as possible leakage, overheating, or burning of the battery, please note the following. 1. It is forbidden to disassemble the machine and its built-in battery under any circumstances. 2. It is forbidden to charge near a fire or in a hot environment. 3. It is prohibited to cover the equipment with clothing, bedding or other objects. 4. It is forbidden to throw the product into the fire. 5. Do not put the battery into a microwave oven or high pressure container. If the electrolyte of the built-in battery leaks and comes into contact with the skin or other parts of the body, stop using the product immediately and wash it with water. Do not use the product if it emits an odor, becomes hot, deformed, discolored, or if any other abnormalities occur. If the product is in use or charging, stop charging and use immediately.
Please press the following button to download more instruction!

Download